/ how it's built
EN UA
Pre-order
01

How Desky is built

Desky is a small robot that sits on your desk beside the laptop and shows what your coding agent is doing: it types while Claude Code or Codex writes code, reads when it reads, and calls you when it needs an answer.

Four MG90S servos turn him on the chair, tilt the body and move two arms. The face is a 2-inch screen; the brain is a Waveshare ESP32-S3 Zero inside the body. The body is glued together, so only a few small screws are needed.

4 × MG90Sturn, tilt, two arms
1 screenthe face
3D-printedPLA, body glued
4 stagesprint, solder, assemble, flash
Desky on his desk, from the CAD model of the set.
Inside the body: the servo and board layout.
The body from behind: servos and mounts.
02

Four stages

  1. Print

    The parts are printed in PLA. The first plate is a short test run of small pieces, so a mistake shows up before the big plates are started.

    The longest stage in printer time. The printer works on its own while you do the rest.

  2. Solder and wire

    The board and the servos are wired together and tested on the bench before anything goes into the body.

  3. Assemble

    The body is glued in order: base and column, seat, body, face, side plates and arms. Then the desk and the props.

  4. Flash and calibrate

    The firmware goes onto the ESP32, each joint is calibrated, and Desky is connected to Claude Code or Codex.

ROUGH TIMINGFor a first build, plan one or two evenings for each stage except printing.
03

What you need

  • A 3D printer big enough for the plates. The documentation has the files laid out for the A1 mini.
  • PLA filament in the colour you pick.
  • Electronics: a small ESP32-S3 board, four servos, a 2-inch screen, and the wires and connectors that join them.
  • A soldering iron, a few hand tools, glue and a handful of small screws.
  • A laptop with Claude Code or Codex, and a USB-C cable.

The full list, with quantities and where to buy each part, is in the documentation.

04

The documentation

Everything for the build is in the paid documentation, sold on its own for 1 000 UAH (about $24).

  • An interactive step-by-step guide, with the parts and tools for each step.
  • A 3D viewer for every part and its place in the assembly.
  • Print files (STL) laid out for the A1 mini.
  • Wiring diagrams, the firmware and how to flash it.
  • Calibration, the software setup and an FAQ.

Buy the documentation